Instructions

FOLIAR APPLICATION

1. Use R/o water whenever possible, if not, tap water will be ok

2. Fill a high-quality sprayer (or fogger) with water

3. Add EPW at the following rates depending on your needs:

a. Sensitive Plants: 0.5% (5ml per 1L water)

b. Maintenance Spray: 1% (10ml per 1L water) 

c. Heavy Cleaning: 1.5% (15ml per 1L water) 

4. Shake the sprayer to ensure that the solution is properly mixed 

5. Starting at the base of the plant, spray the substrate and then slowly move up until the plant is fully saturated. Make sure to cover the upper and lower sides of the leaves as well as the stem and branches.

HOW OFTEN CAN I APPLY?

Daily - EPW can be applied daily if necessary 

Maintenance - Ideally done 2x per week

Heavy cleaning - Ideally done 3x per week 

OUTDOOR APPLICATION

If possible, apply close to sunrise or sunset, this should help avoid contact with Bees and beneficial insects. While EPW is safe around most beneficials - we would prefer not to spray EPW directly onto them.

PLANT DIP/DUNK

1. Use R/o water whenever possible, if not tap water will be ok

2. Add water to a bucket

3. Add EPW to the bucket at the following rates depending on your needs:

Cuttings / Clones: 1% (10ml per 1L water) 

Established Plants: 1.5% (15ml per 1L water) 

4. Mix the solution until it is properly blended

5. Dunk plant and keep it submerged for around 5 seconds

RECOMMENDED APPLICATION RATES

Sensitive Herbs: 5ml per litre

Lettuce: 10ml per litre

Hydroponics: 10ml - 15ml per litre

Berries: 10ml per litre

Potatoes: 10ml per litre

Carrots: 10ml per litre

Chilli Plants: 10ml per litre

Eggplant: 10ml per litre 

Tomatoes: 10ml per litre (See Precautions)

*Always dilute EPW before use

Apply when root zone is moist to avoid leaf burn

Test on a small area first

Use within 24hours of mixing for best results

MEDICAL CANNABIS SOP

Are you a medical cannabis facility?

Contact us for a copy of our Standard Operating Procedure & Application guide